TY - JOUR AU - Vasconcelos, Urias Silva AU - Silva, Thalisson Saymo de Oliveira AU - Silva, Daylana Pacheco da AU - Sipaúba, Graciela Maria Oliveira AU - Valente, Valdimar da Silva AU - Zanetti, Raquel Virginia AU - Moura, Carmem Dolores Vilarinho Soares de PY - 2019/09/09 Y2 - 2024/03/28 TI - Effects of the combination of Er:YAG laser and sandblasting on the shear bond strength between zirconia and resin cement JF - Brazilian Journal of Oral Sciences JA - Braz. J. Oral Sci. VL - 18 IS - SE - Article DO - 10.20396/bjos.v18i0.8656586 UR - https://periodicos.sbu.unicamp.br/ojs/index.php/bjos/article/view/8656586 SP - e191449 AB - <p>Aim: This study was conducted to determine the bond strength between zirconia ceramic and resin luting cement according to the type of surface treatment applied. Methods: Sixty zirconia cylinders measuring 4 x 4 mm were manufactured and distributed into five experimental groups and a control group (n = 10): G1 - sandblasting with 110 μm aluminum oxide; G2 - sandblasting with 30 μm Rocatec Soft®; G3 - Er:YAG laser irradiation at 400 mJ; G4 - Er:YAG laser combined with sandblasting with aluminum oxide; G5 - Er:YAG laser combined with sandblasting with Rocatec Soft®; G6 - no treatment (Control). The zirconia cylinders were bonded in the center of composite resin cylinders (6 mm diameter) using RelyX Ultimate® cement. Shear strength was measured after thermocycling (6000 cycles and 5-55° C). Data were analyzed using one-way ANOVA and Tukey's post-hoc with a 5% significance level. Results: Group 4 had a significantly higher shear strength than all the other groups, except Group 1. Group 3 had a significantly lower shear strength compared with Groups 1 and 4. Conclusion: Sandblasting with 110μm aluminum oxide particles after laser irradiation may be an effective zirconia surface treatment. The use of Er: YAG laser alone is not effective at increasing the bond between resin cement and zirconia.</p> ER -