Dual-cured adhesive system improves adhesive properties of dentin cavities restored with a bulk-fill resin composite

Authors

DOI:

https://doi.org/10.20396/bjos.v21i00.8666262

Keywords:

Aging, Polymerization, Composite resins, Dentin-bonding agents, Physical properties

Abstract

Aim: To evaluate the impact of a dual-cured adhesive system on the in situ degree of conversion (DC), bond strength (BS) and failure mode (FM) of adhesive interfaces in dentin cavities restored with a bulk-fill resin composite. Methods: 4-mm-deep dentin cavities with a 3.1 C-factor were created in 68 bovine incisors (n = 17 per group). The lightcured (Scotchbond™ Universal) or the dual-cured (Adper™ Scotchbond™ Multi-purpose Plus) adhesive system was applied to the cavities, which were then restored with a bulkfill resin composite (Filtek™ Bulk Fill). In situ DC analysis was performed by means of micro Raman spectroscopy at the top and bottom interfaces. Push-out BS was measured in a universal testing machine after 24-h or 6-month water storage. FM was determined with a stereomicroscope. Data of in situ DC and BS were analyzed by two-way analysis of variance (ANOVA) and Tukey test (p<0.05), while the FM was analyzed descriptively. Results: The groups that received the dual-cured adhesive system showed statistically higher in situ DC and BS than those that received the light-cured adhesive system. Cohesive failure mode was the most frequent in all conditions. Conclusion: In situ DC and BS were influenced by the curing strategies of the adhesive systems with better performance of the dual-cured material.

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Author Biographies

Ana Margarida dos Santos Melo, Federal University of Rio Grande do Norte

Department of Dentistry, Federal University of Rio Grande do Norte (UFRN), Natal, Rio Grande do Norte, Brazil.

Anne Kaline Claudino Ribeiro, Federal University of Rio Grande do Norte

Department of Dentistry, Federal University of Rio Grande do Norte (UFRN), Natal, Rio Grande do Norte, Brazil.

Diana Araújo Cunha, Federal University of Ceará

Department of Restorative Dentistry, School of Dentistry, Facult of Pharmacy, Dentistry and Nurse, Federal University of Ceará (UFC), Fortaleza, Ceará, Brazil.

Nara Sousa Rodrigues, Federal University of Ceará

Department of Restorative Dentistry, School of Dentistry, Facult of Pharmacy, Dentistry and Nurse, Federal University of Ceará (UFC), Fortaleza, Ceará, Brazil.

Vicente de Paulo Aragão Saboia, Federal University of Ceará

Department of Restorative Dentistry, School of Dentistry, Facult of Pharmacy, Dentistry and Nurse, Federal University of Ceará (UFC), Fortaleza, Ceará, Brazil.

Boniek Castillo Dutra Borges, Federal University of Rio Grande do Norte

Department of Dentistry, Federal University of Rio Grande do Norte (UFRN), Natal, Rio Grande do Norte, Brazil.

Isauremi Vieira de Assunção, Federal University of Rio Grande do Norte

Department of Dentistry, Federal University of Rio Grande do Norte (UFRN), Natal, Rio Grande do Norte, Brazil.

References

Ferracane JL, Greener EH. The effect of resin formulation on the degree of conversion and mechanical properties of dental restorative resins. J Biomed Mater Res. 1986 Jan;20(1):121-31. doi:10.1002/jbm.820200111.

Breschi L, Mazzoni A, Ruggeri A, Cadenaro M, Di Lenarda R, De Stefano Dorigo E. Dental adhesion review: aging and stability of the bonded interface. Dent Mater. 2008 Jan;24(1):90-101. doi: 10.1016/j.dental.2007.02.009.

Cadenaro M, Antoniolli F, Sauro S, Tay FR, Di Lenarda R, Prati C, et al. Degree of conversion and permeability of dental adhesives. Eur J Oral Sci. 2005 Dec;113(6):525-30. doi: 10.1111/j.1600-0722.2005.00251.x.

Tay FR, Pashley DH, Suh BI, Carvalho RM, Itthagarun A. Single-step adhesives are permeable membranes. J Dent. 2002 Sep-Nov;30(7-8):371-82. doi: 10.1016/s0300-5712(02)00064-7.

Faria-e-Silva AL, Casselli DS, Lima GS, Ogliari FA, Piva E, Martins LR. Kinetics of conversion of two dual-cured adhesive systems. J Endod. 2008 Sep;34(9):1115-8. doi: 10.1016/j.joen.2008.06.016.

Arrais CA, Rueggeberg FA, Waller JL, de Goes MF, Giannini M. Effect of curing mode on the polymerization characteristics of dual-cured resin cement systems. J Dent. 2008 Jun;36(6):418-26. doi: 10.1016/j.jdent.2008.02.014.

Shirai K, De Munck J, Yoshida Y, Inoue S, Lambrechts P, Suzuki K, et al. Effect of cavity configuration and aging on the bonding effectiveness of six adhesives to dentin. Dent Mater. 2005 Feb;21(2):110-24. doi: 10.1016/j.dental.2004.01.003.

Borges BC, Vilela AR, da Silva-Junior CA, Souza-Junior EJ, Sinhoreti MA, Pinheiro FH, et al. Dual-cured etch-and-rinse adhesive systems increase the bond durability of direct coronal dentin restorations. Oper Dent. 2013 Sep-Oct;38(5):512-8. doi: 10.2341/12-246-L.

Campodonico CE, Tantbirojn D, Olin PS, Versluis A. Cuspal deflection and depth of cure in resin-based composite restorations filled by using bulk, incremental and transtooth-illumination techniques. J Am Dent Assoc. 2011 Oct;142(10):1176-82. doi: 10.14219/jada.archive.2011.0087.

Sousa-Lima RX, Silva L, Chaves L, Geraldeli S, Alonso R, Borges B. Extensive assessment of the physical, mechanical and adhesion behavior of a low-viscosity bulk fill composite and a traditional resin composite in tooth cavities. Oper Dent. 2017 Sep/Oct;42(5):E159-66. doi: 10.2341/16-299-L.

Chaves LVF, Oliveira SN, Özcan M, Acchar W, Caldas MRGR, Assunção IV, et al. Interfacial properties and bottom/top hardness ratio produced by bulk fill composites in dentin Cavities. Braz Dent J. 2019 Oct 7;30(5):476-83. doi: 10.1590/0103-6440201902741.

Rodrigues NS, Souza LC, Feitosa VP, Loguercio AD, D’Arcangelo C, Sauro S, et al. Effect of different conditioning/deproteinization protocols on the bond strength and degree of conversion of self-adhesive resin cements applied to dentin. Int J Adhes Adhes. 2018 Mar;81:98-104. doi: 10.1016/j.ijadhadh.2017.03.013.

Sousa-Lima RX, Melo AMS, Guimarães LKC, Souza ROA, Caldas MRGR, Assunção IV, et al. Mechanical properties of low and regular viscosity bulk fill composites in a 3D dentin cavity model. J Adhes Sci Tech. 2020 Sep 10; 35(3):325-35. doi: 10.1080/01694243.2020.1802134.

Van Meerbeek B, Yoshihara K, Van Landuyt K, Yoshida Y, Peumans M. From Buonocore's pioneering acid-etch technique to self-adhering restoratives. A status perspective of rapidly advancing dental adhesive technology. J Adhes Dent. 2020 22(1):7-34. doi: 10.3290/j.jad.a43994.

Chen C, Niu LN, Xie H, Zhang ZY, Zhou LQ, Jiao K, et al. Bonding of universal adhesives to dentine - Old wine in new bottles? J Dent. 2015 May;43(5):525-36. doi: 10.1016/j.jdent.2015.03.004.

Muñoz MA, Luque-Martinez I, Malaquias P, Hass V, Reis A, Campanha NH, et al. In vitro longevity of bonding properties of universal adhesives to dentin. Oper Dent. 2015 May-Jun;40(3):282-92. doi: 10.2341/14-055-L.

Valizadeh S, Moradi A, Mirazei M, Amiri H, Kharazifard MJ. Microshear bond strength of different adhesive systems to dentin. Front Dent. 2019 Jul-Aug;16(4):265-71. doi: 10.18502/fid.v16i4.2085.

Ikemura K, Endo T. Effect on adhesion of new polymerization initiator systems comprising 5-monosubstituted barbituric acids, aromatic sulphonate amides, and tert-butyl peroxymaleic acid in dental adhesive resin. J Appl Polym Sci. 1999 Apr;72(13):1655-68. doi: 10.1002/(SICI)1097-4628(19990624)72:13<1655::AID-APP2>3.0.CO;2-0.

Breschi L, Cadenaro M, Antoniolli F, Sauro S, Biasotto M, Prati C, et al. Polymerization kinetics of dental adhesives cured with LED: correlation between extent of conversion and permeability. Dent Mater. 2007 Sep;23(9):1066-72. doi: 10.1016/j.dental.2006.06.040.

Navarra CO, Cadenaro M, Armstrong SR, Jessop J, Antoniolli F, Sergo V, et al. Degree of conversion of filtek silorane adhesive system and clearfil SE bond within the hybrid and adhesive layer: an in situ Raman analysis. Dent Mater. 2009 Sep;25(9):1178-85. doi: 10.1016/j.dental.2009.05.009.

Flury S, Peutzfeldt A, Lussi A. Influence of increment thickness on microhardness and dentin bond strength of bulk fill resin composites. Dent Mater. 2014 Oct;30(10):1104-12. doi: 10.1016/j.dental.2014.07.001.

Peumans M, Wouters L, De Munck J, Van Meerbeek B, Van Landuyt K. Nine-year clinical performance of a HEMA-free one-step self-etch adhesive in noncarious cervical lesions. J Adhes Dent. 2018 20(3):195-203. doi: 10.3290/j.jad.a40630.

Van Meerbeek B, Yoshihara K, Yoshida Y, Mine A, De Munck J, Van Landuyt KL. State of the art of self-etch adhesives. Dent Mater. 2011 Jan;27(1):17-28. doi: 10.1016/j.dental.2010.10.023.

Scotti N, Cavalli G, Gagliani M, Breschi L. New adhesives and bonding techniques. Why and when? Int J Esthet Dent. 2017 12(4):524-35.

Downloads

Published

2022-01-03

How to Cite

1.
Melo AM dos S, Ribeiro AKC, Cunha DA, Rodrigues NS, Saboia V de PA, Borges BCD, Assunção IV de. Dual-cured adhesive system improves adhesive properties of dentin cavities restored with a bulk-fill resin composite. Braz. J. Oral Sci. [Internet]. 2022 Jan. 3 [cited 2022 May 25];21(00):e226262. Available from: https://periodicos.sbu.unicamp.br/ojs/index.php/bjos/article/view/8666262

Issue

Section

Original Research

Most read articles by the same author(s)